* – Still not enough ram on CC for gps to be usable * – Icons on Welcome tab – moves to the left * – CCPM Config Widget crashes GCS if required boxes aren’t set i.e. * – Input Configuration Wizard has scrollbars showing up and next/previous buttons are pushed down out of sight Release Notes – OpenPilot – Version RELEASE-15.02 Note for CC3D/CC: To support PWMSync/OneShot125 PPM input pin has changed from earlier releases to the last pin on the input IO port, please refer to the connection diagram in the setup wizard to see the required new pin layout for PPM. Note that OneShot125 support has the same restrictions as PWMSync for CC and CC3D. This release also introduces support for OneShot125 capable ESCs, such as the KISS ESCs and all ESCs supported in BLHeli V13 and above. Compatible input methods are PPM, S.Bus, DSM and OPLink. Some restrictions applies to CC3D/CC as it needs a compatible input method to enable PWMSync. Visit the OpenPilot Downloads page to download:Ī key improvement that helped achieve this was the addition of the PWMSync code path, this is now enabled by default. This is a recommended upgrade for everyone and the more skilled of a pilot you are, the more you will love this release. In our testing, we have found this to be not only the best flight performance so far in the OpenPilot project but the best flight performance of any project we have tested against. Many enhancements have been made to reducing dead-time of the communication between the flight controller and ESCs. This release introduces major flight performance improvements, enhancements as well as bug fixes.

What is OpenPilot? – We’re an all volunteer, open source community that creates hardware and software (flight controllers, firmware, and ground control station) for civilian UAVs and other vehicles.

This is our second release of 2015, OpenPilot Version 15.02 (Ragin’ Cajun).

Openpilot gcs 15.02.02 download